So I started getting alerts from my Victron Multiplus….AC overloads. Well wat the Frell!
So you go to the boat. open the hatch and you see flashing light, turn off the multi , wait a bit and turn it back on and all seems to be working fine and you go home. Later you get again a overload warning, so you use the VRM website to get into the Venus control unit remotely, and set the inverter to charge only. Drive back to the boat and recheck it…and the same problem …it ain’t working….so you call your dealer where you bought it, and hear…… “Most likely the AC board I have seen this before ” and he provides and RMA and yes he sends at the same time a replacement unit, since it is still under the 5 year warranty !!
The new unit arrives. Plop it in its place and reconnect all wires, turn it on …and magically…the light work …..So you plug the table into the Venus and poof all goes dark. Ok …must have put it in the wrong input. ve.net, ve.can .ve.direct…..but NO it happens a few second after you plop the network cable in. This happened a year ago also , and then it was a software update on the Venus which did this. A call to Daniel…and I was gently reminded that the moment the Venus detects the multi it will set it in the function set in the Venus, which was not the same as the switch on the machine……so I get into the Venus control , set the Multi to normal and voila….as the professor in the movie the 5th element shouts…”Aziz . LIGHTS”.
So before thinking it was Victrons error…we just have to check the Venus settings.